HF Series
(20-21250 scfm)
A typical compressed air system is contaminated with abrasive solid particles such as dust, dirt, rust and pipe scale, compressor lubricants (mineral or synthetic), condensed water droplets and acidic condensates and oil and hydrocarbon vapors. If not removed, these contaminants increase pneumatic equipment maintenance costs, lead to instrument and control failure, contribute to poor product fit and finish and contaminate processes.
The right Hankison filter or filter system will remove these contaminants allowing your compressed air system to deliver the quality of air required by your application; whether it’s plant air, instrument air, or medical air–helping to ensure consistent output quality while minimizing operating costs.
HTA Series High Temperature
(Temperatures to 450°F)
Compressed air leaves a desiccant dryer containing dust concentrations typically in the range of up to 0.05ppm by weight in heatless type dryers and up to 5 ppm by weight in heated type dryers. Particle size ranges from 200 microns to about 1 micron. This desiccant laden compressed air enters the filter housing where a reduction in air velocity and a sharp change of direction cause particles in the range of 200 to 20 microns to drop to the bottom of the housing.
M Series Mist Eliminators
(100% Of particles 3 microns and larger)
Hankison M Series Mist Eliminators protects products and processes from contamination and increases the life of pneumatic equipment. M Series is an auditors choice to reduce energy costs and remove oil and water aerosols from compressed air systems.
NGF Series
( 20-1500 scfm)
The NGF Series employs technological advancements in filtration materials and design to ensure premium compressed air quality and low operational costs. Every filter is tested and rated delivering certifiable performance according to ISO 8573-1 air quality standards. The NGF Series is tested to ISO 12500. Test results provide certifiable performance data based on defined challenge concentrations.
