DHW Series Heatless Regenerative
(-40°F / 10 minute cycle)
Minimum purge air usage saves the heat of adsorption, maximizing the moisture holding capacity of the purge air which minimizes the amount required. Standard 10 minute cycle gives increased desiccant life over units operating on shorter cycles. DHW Series dryers allow the off-stream tower to fully repressurize before going on-stream preventing bed movement and loss of pressure downstream.
HBP Series Blower Purge
(-40°F dew point)
HBP Series dryers improve air system efficiency by the use of a dedicated axial blower, instead of a percentage of dehydrated purge air, to regenerate the off-line desiccant tower. ISO 8573.1 Class 2 (-40°F/-40°C) dew point performance is guaranteed. HBP Series compressed air dryers will produce the design dew point while operating continuously at maximum rated flow (100% duty cycle) at CAGI ADF 200 inlet standards of 100°F inlet temperature and 100% relative humidity at 100 psig.
HCD Series Heat of Compression
(350-1000 scfm)
The Hankison HCD Series provides a cost effective solution to remove moisture from compressed air. The sustainable energy saving design reduces operating costs and delivers instrument quality air.
Thermal energy generated during the air compression process is effectively utilized to regenerate the off-line desiccant bed. Ideally suited for oil-free air compressors, HCD series dryers turn “waste heat” into energy savings.
HDF Series Single Tower
(Dew points to -40°F)
State-of-the-art refinish materials and moisture-sensitive pneumatic tools require compressed air treatment. Modern spray guns, particularly HVLP, require greater volumes of air to atomize today's high-solids coatings. Greater volumes of air carry greater volumes of water, oil, and dirt which must be removed. A HDF Series compressed air dryer can eliminate that damaging water, dirt, and oil which can ruin your refinish work.
HHL, HHS and HHE Series Heatless
(Dew points to -100°F)
Utilizing twin towers filled with premium grade activated alumina, Hankison Heatless dryers are available with 3 application specific control systems to meet the needs of industry with economy and performance.Hankison HHS, HHL and HHE Series heatless desiccant dryers provide consistent outlet pressure dew points to -100°F (73°C).
HPD Series Heated Blower Purge
(-4°F to -40°F Dew Points)
Hankison HPD Series dryers will produce the design dew point while operating continuously at maximum rated flow (100% duty cycle) at CAGI ADF 200 inlet standards of 100°F inlet temperature and 100% relative humidity at 100 psig.
